Commercial roof coating · Orlando and Florida's Space Coast

Do not replace your roof.
Restore it.

Prime Site restores flat and low-slope commercial roofs with a 100% silicone coating system, applied over the roof you already have. No tear-off, no debris, no shutting down your operation.

From $3 per square foot installed, a fraction of the cost of a full replacement.

We protect your site from the top down.

100%silicone coating system
Up to 20 yearswarranty options, by system thickness
$3 to $6per sq. ft. installed, typical range
Zerotear-off, landfill debris or shutdown

The problem

A failing roof leaves you two bad options. There is a third.

Leaks over inventory, tenants or equipment. A membrane at the end of its life. And a replacement quote that stops you cold, because a full tear-off means the highest cost in the building, weeks of disruption and tons of debris to the landfill.

Patching buys weeks. Replacement buys decades, at full price. Restoration buys 10 to 20 more years out of the roof you already paid for, when the roof underneath is still structurally sound. That is the honest condition: coating restores sound roofs. If yours is beyond that point, we will tell you at the free assessment, before you spend anything.

The math, on a 10,000 sq. ft. roof

Silicone coating restoration $30,000 to $60,000 At the typical $3 to $6 per sq. ft. installed range. Work happens over your operating business, with no tear-off.
Full tear-off and replacement The most expensive line item in the building Demolition, disposal, new materials and a longer, disruptive job. Ask your replacement quote for its per-square-foot number and compare it with ours.

Every roof is measured before a firm price. Your firm number comes from a satellite measurement of your actual roof, confirmed at a free on-site assessment.

How it works

A firm price in three steps, without a sales visit first

1

Tell us about your roof

Message us on WhatsApp or send the short form with your roof address and its approximate size. You get the price range for your roof right away, based on the typical $3 to $6 per square foot installed.

2

We measure it by satellite

With your address, we measure your roof on satellite imagery: area, slopes and penetrations. That measurement turns the range into a firm price, calculated at the warranty level you choose.

3

Free on-site assessment

Satellite cannot see the condition of your membrane, so the firm price is confirmed at a free assessment visit. We check adhesion, moisture and problem areas, then schedule the work. No surprises after signing.

The system we install

GacoFlex S42: 100% silicone, built for Florida roofs

We apply the GacoFlex S42 Series by Gaco, a professional 100% silicone roof coating for flat and low-slope roofs. Silicone is the chemistry that fits Florida: it handles standing water, UV and heat without breaking down the way other coatings do, and almost everything applied stays on the roof, because the system is about 96.5% solids.

100%

Silicone, solvent-free

Single-component, moisture-cured silicone with high adhesion. On most substrates it needs no primer.

96.5%

Solids by weight

95% solids by volume, so the wet coat you see is close to the dry film that protects you. One coat typically sets the system thickness.

0.87

Initial solar reflectance

The white finish reflects the Florida sun off your roof, which eases the heat load on the building below. Reflectance after weathering: 0.81.

Standing water

Made for ponding areas

Silicone does not degrade in standing water, the classic weak point of acrylic coatings on flat roofs.

Under 50 g/L

Low VOC

A low-emission system, applied while your business keeps operating underneath it.

FL approved

Florida Building Code

Florida Product Approvals FL14724 and FL14723, and Miami-Dade Product Control Approved, per the manufacturer's current data sheet.

Roofs it restores

  • Metal roofs
  • EPDM
  • TPO
  • PVC and other single-ply membranes
  • Aged asphalt, built-up and modified bitumen
  • Spray polyurethane foam
  • Concrete
  • Existing elastomeric coatings (recoat)

Product data from the manufacturer's published data sheet for the GacoFlex S42 Series. Gaco and GacoFlex are trademarks of Gaco, Amrize Building Envelope LLC. Prime Site is an independent contractor and does not speak for the manufacturer.

Warranty options

Choose your horizon: 10, 15 or 20 years

With the GacoFlex S42 system, the protection level is set by one number: the dry film thickness we apply. More thickness, longer warranty option. Options up to 20 years, depending on system thickness.

10 years 18 mils dry film thickness

Applied at about 1.25 gallons per 100 sq. ft. The efficient restore for a sound roof that needs a new lease on life.

20 years 34 mils dry film thickness

Applied at about 2.25 gallons per 100 sq. ft. The maximum protection level the S42 system offers.

Warranty options depend on the system thickness applied, the condition of your roof and the manufacturer's program requirements for the project, including project registration and inspections where required. The warranty that applies to your roof is confirmed in writing before work begins. Nothing on this page is a promise of a specific warranty for a specific roof.

Our work

Roofs already restored on Florida's Space Coast

Our coating crews have already completed commercial roofs with this same silicone system in Cocoa Beach and Ormond Beach. Project photography is being prepared for this page.

Cocoa Beach, FL Commercial roof restoration Photography coming soon
Cocoa Beach, FL Commercial roof restoration Photography coming soon
Ormond Beach, FL Commercial roof restoration Photography coming soon

Questions

Before you ask, the straight answers

Most flat and low-slope commercial roofs do, if the roof underneath is still structurally sound and dry: metal, EPDM, TPO, PVC, aged asphalt and built-up roofs, spray foam, concrete and existing coatings. The free assessment settles it: we test adhesion and check for trapped moisture before quoting a firm price. If your roof does not qualify, we say so plainly.

Most restorations take days, not weeks: cleaning and preparation, detail work on seams and penetrations, then the silicone coat. There is no demolition phase, which is where replacement jobs spend much of their time.

No. The system is applied over your existing roof while your operation continues below. That is one of the main reasons owners choose restoration over replacement.

Silicone is the right chemistry for it. Unlike acrylic coatings, silicone does not degrade sitting in standing water, which is why it is the standard choice for flat roofs with ponding areas.

From two things: your roof's measured area, taken by satellite from your address, and the warranty level you choose, which sets the system thickness. The typical installed range is $3 to $6 per square foot. Your firm price is confirmed at the free assessment, because only an on-site look can verify the condition of the roof under the coating.

Very little: keep drains clear and have the roof looked at once a year. If the coating is ever damaged, it is repaired with compatible silicone, and future recoats are applied in silicone over the existing system.

Free roof assessment

Get the range for your roof

Send four details and we come back with the price range for your roof, then the firm price from a satellite measurement of your address. The on-site assessment is free.

Prefer WhatsApp? Start there

Serving Orlando and Florida's Space Coast: Cocoa Beach, Ormond Beach and the surrounding commercial corridors.

No spam, no obligation. Your details are used only to price and assess your roof.